Publicidad
Idiomas disponibles
Idiomas disponibles
When you Want More Control over Individual Massage Settings_
1. Press ©.
user
2. Select and press the User Memory Button you require. pp
(You can actually press one of the User Program buttons without pressing ®.)
rg~
3. Select and press the program you desire, (i.e., shiatsu, deep, gentle, refresh, Self Prog.)
The specific treatment areas you recorded are displayed.
• The massage lounger will carry out body searching to check whether or not someone with the same physical
characteristics is using the unit. (Nothing will be displayed and no sounds will be emitted during this period.)
If the physical characteristics are the same as those recorded the previous time then the massage will start immediately. If,
however, the physical characteristics are determined to be different then body searching will be carried out in the normal
way before the massage begins.
(
T
Creating a Customized Program
After following the procedures outlined on this page and the previous page, after the program has
finished and while the button is still flashing press the same User Memory Button. You must press A or
B or C to record any changes made.
v_
)
Erasing Recorded Data
• It is possible to restore the factory default settings.
(It is not possible to return to the previously recorded User Program setting.)
(1) Press ®.
user
(2) Select and press the button with the information you want to erase.
f
• The button will stop flashing and the Programmed Operation buttons will start flashing, fug
(3) Hold the same button down (for at least 3 seconds) until
[
**
[*&*}
and [1 stop flashing.
• The button selected will start to flash (for approximately 15 seconds).
(4) Press the same button again while it is flashing.
• The data recorded will be erased and the button will stop flashing.
20
Publicidad
