Publicidad
Idiomas disponibles
Idiomas disponibles
OTHER SAFETY WARNINGS
•
Maintain the unit with care.
All service, other than the maintenance procedures described in
this manual, should be performed by a Sears or other qualified
service dealer.
Never remove, modify or make inoperative any safety device
furnished with the unit.
Before inspecting, servicing, cleaning, storing, transporting
or
replacing any parts on the unit:
1. Stop the unit.
2. Make sure all moving parts have stopped.
3. Allow the unit to cool.
4. Disconnect the spark plug wire.
Secure the unit while transporting.
Never store the unit with fuel in the tank, inside a building where
fumes may reach an open flame (pilot lights, etc.) or sparks
(switches, electrical motors, etc.).
Store the unit in a dry place, secured or at a height to prevent
unauthorized
use or damage. Keep the unit out of the reach of
children.
Never douse or squirt the unit with water or any other liquid.
Keep handles dry and clean (free from debris, oil and grease).
Clean the unit after each use. Refer to Cleaning and Storage. Do
not use solvents or strong detergents.
Keep these instructions.
Refer to them often and use them to
instruct other users. If you loan this unit to others, also loan
them these instructions.
SAVE THESE INSTRUCTIONS
• SAFETY
& iNTERNATiONAL
SYMBOLS
•
This operator's
manual describes safety and international symbols and pictographs
that may appear on this product. Read the operator's
manual for complete safety, assembly, operating and maintenance and repair information.
SYMBOL
MEANING
SYMBOL
MEANING
. SAFETY ALERT SYMBOL
j
Indicates
danger, warning or caut!on. May be used in
_
I c°njuncti°n
with °ther symbo!s Or Pict0graphs.
o READ OPERATOR'S
MANUAL
WARNING"
= Read the operator's
manual(s) and follow all warnings and safety
instructionsl
Failure to do so Can result in serious
injury to the 0perat0r and!0r bystander&
4t
_ " WEAR EYEAND
HEARING PROTECTION
,,,-,n,,..,
h,owo
objects ,cud
m
_
noise can cause severe eye injury and hearing loss:
v
Wear eye Protection meeting current ANSI ! ISEA
Z87:1 standards and ear protection when operating
this unit. Use a full face shield when needed.
A!ways use Ciean; fresh UUleaded fuei,
,OIL
7-_7J
Refer t0 0perat0r S manual foi the proper type 0f 0il.
* DO NOT USE E85 FUELIN THiS UNIT
WARN IN
G
== i has been
:[]
piovei
;hat ;_
_.
c_nt !ig ieng i! re_t_rn thar?d!Oofdtthhanw°lr Wi!nlt Ickely
--
' ON/OFF STOP CONTROL
ON / START/RUN
' ONIOFF STOP CONTROL
OFF or STOP
Push primer bulb, fully and slowly, 10 times.
÷lTj.d _
' THROWN OBJECTS AND ROTATING CUTTER CAN
CAUSE SEVERE 'NJUR i
ob
bewa
//__/"_/_---_" We iAeledRatN _ NeG
Sma_
jects Kan
pr pe
"g
p e , aus" g'njuy,
p
y
. from the rotating rotor.
KEEP BYSTANDERS AWAY
esWeciAallRchiNId!eNan9--" ! eKeep a_bY5tfnltrs5
m
p
" y:"
n
p
,
(1
)
from the operating area.
_d
' HOT SURFACE
[]
orWcA
err. N
LN
Get i D°:°t_hUCh
ah_st r_tff er
y'd.
b
yg
u
d.
p
g
extremely hot from operation. When turned off they
remain hot for a short time.
_._
' SHARP BLADE
[]
"_
WhAeRnt
NING_¢ht
_rtoladl n°nrt r domerot
_,
a
m
s "
.-i_ p
e
i
i j y,
. touch the line cutting blade.
Publicidad
