Agri-Fab 45-0613 Manual Del Usuario página 14

SERVICE AND ADJUSTMENTS
TO ADJUST BLADE SPRING
The tension of the Blade Adjust Spring may be altered
to permit the Blade to tilt froward to bypass solid
obstructions. To change the Spring Tension, adjust the
Nuts at the upper end of the Spring Bolt. Standing in front
of Blade, turn the nuts counterclockwise to relieve tension
and clockwise to increase tension. Refer to Figure 7.
TO ADJUST BLADE SHOES (FIGURE 21)
The Blade Shoes at the ends of the Blade may be raised
for close work on smooth surfaces or lowered to raise
the blade to work on rough or uneven areas. Make sure
both shoes are set evenly and that the nuts are tightened
securely.
Snow Blade
TO ADJUST THE BLADE PIVOT LOCK
MECHANISM (FIGURE 22)
If the Blade will not unlock and pivot, the Angle Lock
Bars are not disengaging from the slots in the pivot plate.
To correct, adjust the 5/16" hex jam nuts to draw the
end of the Control Cable back towards the Cable Mount
Bracket. The less the threaded end of the cable through
the bracket, the more the Angle Lock Bars can retract to
disengage from the slots in the Pivot Plate.
Cable Mount Bracket
5/16" Hex
Jam Nut
Blade Shoe
FIGURE 21
Control
Cable
5/16" Hex
Jam Nut
FIGURE 22
STORAGE
RECOMMENDATIONS WHEN STORING
• When the Snow Blade is not being used, remove all
dirt and rust and touch up with paint.
• Touch up bare metal with paint or apply a light coat of
grease or rust preventative.
• Lubricate all pivot points and all points shown in
Figure 19 of the Maintenance section.
• Store in a dry area, protected from weather.
TO REMOVE BLADE FROM MOWER
• Lower the blade to the ground with the Blade in the
center (Straight Ahead) position.
• Remove the 3/8" Nylock Nut (L) and 3/8" Hex Bolt
(H) that secures the Blade Mount Assembly (5) to the
Hitch Mount Assembly (1).
• Slide the Blade Mount Assembly (5) out of the Hitch
Mount Assembly (1).
TROUBLESHOOTING
Problem Cause
Blade is Lift Mechanism is
difficult to binding.
raise.
Blade is Handle Tube is
difficult to binding on Lift Rod.
pivot.
Blade will not Lock mechanism is
unlock to pivot. out of adjustment
and is not
disengaging.
14
Correction
Lubricate pivot
points as shown in
Figure 19
Lubricate the Lift
Handle Rod as
shown in Figure 19.
Refer to the Service
and Adjustments
section.