Agri-Fab 45-0613 Manual Del Usuario página 9

ATTACH THE CONTROL CABLE TO THE
CHANNEL SUB ASSEMBLY
STEP 8:
(SEE FIGURE 8)
• Insert the ball end of the control cable (11) into the
bottom of the clevis lanyard fitting (U) and place the
cable into the groove as shown.
• Place a spacer (R) onto the hole on the channel sub
assembly (9) as shown; then place the clevis lanyard
fitting (U) on top of the spacer (R) and secure both
parts to the channel sub assembly (9) with a hex bolt
(C) and hex nut (I). Tighten hardware.
• Install one 5/16" jam nut (J) approximately 3/4" onto
the threaded end of the control cable that has no
rubber cap or preassembled nuts.
• Insert the control cable (11) into the tab (9a) and
secure with another 5/16" jam nut (J). Tighten both
jam nuts (J).
NOTE: Some adjustment of jam nuts may be required
after blade assembly is completed
9a
11
U
11
J
11
C
U
R
9
9a
I
FIGURE 8
ATTACH THE BLADE ASSEMBLY TO THE
BLADE MOUNT ASSEMBLY
STEP 9:
(SEE FIGURE 9)
• Slide the channel sub assembly (9) into the assembly
pivot support bracket (8) on the blade mount assembly.
Place a washer (P) on a channel pivot pin (S); then
slide the channel pivot pin through the holes on both
assemblies and secure with a hair pin (T).
• Insert the lift handle assembly (13) on the pivot support
bracket assembly (8) as shown and then securing the
lift handle assembly (13) using a hair pin (T).
T
T
9
13
8
S
P
9
T
FIGURE 9
13
T