Agri-Fab 45-0613 Manual Del Usuario página 8

ASSEMBLE THE BLADE ASSEMBLY
STEP 6:
(SEE FIGURE 6)
• Center the channel sub assembly (9) between the tabs
on the back of the blade assembly (18).
• Slide the blade pivot shaft (10) through the holes in the
tabs and the holes in the channel sub assembly (9).
• Secure the blade pivot shaft (10) on both ends using
two cotter pins (V) by bending the ends.
V
V
10
18
9
FIGURE 6
STEP 7:
(SEE FIGURE 7)
• Insert a hex bolt (G) all the way through the trip
spring (X) and place a hex nut (K) one (1) inch onto
the hex bolt as shown.
• Place the hook on the end of the trip spring (X) around
the shaft of the channel sub assembly (9) with the
hook opening facing the blade assembly (18).
• Insert the bolt end of the spring trip (X) into the hole at
the center of the blade assembly (18) and tighten the
hex nut (K); then secure with another hex nut (K) and
tighten.
• Place the vinyl cap (Q) on the end of the hex bolt (K).
Q
K
18
8
X
G
K
X
9
FIGURE 7