Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(2) Adjustable Wrench
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches
(1) Rubber Mallet
Lay out and identify the parts and hardware using the
illustrations on page 3 and page 4.
ASSEMBLE THE HITCH MOUNT ASSEMBLY
STEP 1:
(SEE FIGURE 1)
• Insert a slider tube (2) into each end of the hitch
mount assembly (1).
• Attach the slider tube to the hitch mount assembly
using two hex bolts (E), four washers (O), and two
Nylock hex nuts (L). Do not tighten.
E
O
1
O
L
2
2
FIGURE 1
STEP 2:
(SEE FIGURE 2)
• Attach the hitch mount assembly (1) to the tractor
frame using two U-bolts (4) secured with two mounting
brackets (3), four washers (N), and four hex nuts (K).
Do not tighten.
• If the slider tube does not fully extend into both
U-bolts (4), then loosen the appropriate hex bolt (E)
and reposition the slider tube (2).
• Center the hitch mount assembly on the tractor frame.
• Tighten all hex bolts and hex nuts.
Note: Depending on your mower, U-bolts may need to be
installed at an angle.
K
N
3
4
2
1
6
E
FIGURE 2
Publicidad
