Publicidad
Idiomas disponibles
Idiomas disponibles
FEATURES
PRODUCT SPECIFICATIONS
Grinding Wheel Capacity ........................................4-1/2 in.
No Load Speed ................................................... 9,200/min
Spindle Thread ......................................... 5/8 in. x 11 UNC
ASSEMBLY
UNPACKING
This product requires assembly.
„ Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be in-
cluded at the time of purchase.
WARNING
Items in this Assembly section are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
„ Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
„ Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
„ If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING
If any parts are damaged or missing do not oper-
ate this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always remove the battery
pack from the product when assembling parts.
Recommended Grinding Wheel
Thickness .................................................... Type 27, 6 mm
Recommended Cutting Wheel
Thickness ................................................... Type 1, 1.2 mm
INSTALLING/REMOVING GRINDING GUARD
See Figures 1 - 2, page 13.
To install:
„ Place the guard on the shoulder of the bearing cap by
aligning index arrows on guard and bearing cap. Press
down on guard until it is fully seated.
„ Depress the guard lever and rotate guard to the correct
position. Refer to Positioning the Grinding Guard.
NOTE: Be sure the raised ridge on the guard is seated in
the groove on the bearing cap.
„ Install disc flange, grinding or cutting wheel, and flange
nut as described later in this section.
„ Tighten flange nut securely by hand or with the wrench
provided.
To remove:
„ Remove the flange nut, grinding or cutting wheel, and
disc flange.
„ Depress the lever and rotate guard to align index arrows
on guard and bearing cap.
„ Remove the guard.
INSTALLING/REMOVING GRINDING WHEEL
See Figure 1, page 13.
WARNING:
Thoroughly inspect a new grinding wheel before you
install it on the grinder.
• Tap lightly around the wheel using a wooden hammer.
• Listen carefully to the resulting sounds. Places with
fissures or cracks will result in a different sound.
Do not use a wheel containing fissures or cracks.
When you install a new grinding wheel, carry out a
no load revolution test of approximately one minute
with the grinding wheel facing a safe direction, i.e.,
away from people or objects.
„ Install the grinding guard.
„ Place the disc flange onto the spindle. Make sure the
flats on the bottom of the disc flange are engaged with
the flats on the spindle.
„ Place the grinding wheel over the spindle.
7 - English
Publicidad
