Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
• Occasionally, pipes and electrical wiring may not be detected by this product. Observe caution
when cutting or drilling into areas that may contain concealed pipes or wiring. The sensor will not
detect live wires inside metal pipe or metal conduit, behind metallic wall covering, or behind some
plywood or other dense materials. Use caution if area has plywood, thick wood backing behind
drywall, or thicker than normal walls.
• The batteries must not be disposed with household waste. Care for the environment and take them
to the collection points provided in accordance with national or local regulations. Dispose of the
product appropriately in accordance with the national regulations in force in your country. Adhere to
the national and country specific regulations.
Maximum output < 1mW
Wavelength 630-640nm
IEC 60825-1:2014
Model#: 54558
Date of manufacture: 2023-11
Capacity: 1200mAh [4.44Wh) 3.7V
Input: 5V
Complies with 21 CFR 1040.10 and 1040.11 except for conformance
with IEC 60825-1 Ed. 3., as described in Laser Notice No.56, dated
May 8, 2019.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference
that may cause undesired operation.
STUD DETECTION
1) Hold unit straight up and down and place flat against wall.
2) Press in and hold the DETECTOR button.
3) Wait for the READY message on LCD screen and two LED lights turn
green.
4) Slide unit slowly across surface of wall without lifting or tilting,
When the left or right LED light turn red, slow down and keep sliding
until CENTER message appears, beep sounds and another LED turns
red.
5) At the same time, the top laser line beam also be projected on the
wall and indicate the center of stud.
AC WIRE DETECTION
Only live AC wires can be detected, AC voltage detection feature works
continually when detecting studs. Once AC voltage detected AC wire
indicator icon will appear. (See instruction manual)
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
BC
2000mA
5
PRODUCT OVERVIEW
F
C
F
A
B
ON
PART
DESCRIPTION
A
Detector On/Off button
B
Laser On/Off/Mode switch button
C
Left LED light
D
Right LED light
E
Two bubble vial
H
E
D
G
F
I
J
PART
DESCRIPTION
F
Laser lines
G
Wall mount bracket
H
Two push pins
I
Bracket accessory
J
Reusable double sided mounting gel pad
6
Publicidad
