Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Room relative humidity less than 80%. If the air conditioner operates in
excess of this figure, the surface of the air conditioner may attract condensa-
tion. Please sets the vertical air flow louver to its maximum angle (vertically to
the floor), and set HIGH fan mode.
To further optimize the performance of your unit, do the following:
Keep doors and windows closed.
Limit energy usage by using TIMER ON and TIMER OFF functions.
Do not block air inlets or outlets.
Regularly inspect and clean air filters.
Other features
Default Setting
When the air conditioner restarts after a
power failure, it will default to the
factory settings: (AUTO mode, AUTO
fan,
24°C
(76°F)).
inconsistencies on the remote control
and unit panel. Use your remote control
to update the status.
Auto-Restart (some models)
In case of power failure, the system will
immediately stop. When power returns,
the Operation light on the indoor unit
will flash. To restart the unit, press the
ON/OFF button on the remote control.
If the system has an auto restart
function, the unit will restart using the
same settings.
Three-minute protection feature (some
models)
A protection feature prevents the air
conditioner from being activated for
approximately
3
restarts immediately after operation.
This
may
cause
minutes
when
Louver Angle Memory Function (some
models)
Some models are designed with a
louver angle memory function. When
the unit restarts after a power failure,
the angle of the horizontal louvers will
automatically return to the previous
position. The angle of the horizontal
louver should not be set too small as
condensation may form and drip into
the machine. To reset the louver, press
the manual button, which will reset the
horizontal louver settings.
Refrigerant
(some models)
The indoor unit will automatically
display "EC" or "EL0C" or flash LEDS
(model dependent) when it detects
refrigerant leakage.
it
9
Leak
Detection
System
V.1
Publicidad
