Tornado TORRENT 28 Manual De Operaciones Y Mantenimiento página 37

Fault
Sweeper does not sweep
correctly.
Device raises dust.
Electrical fault.
TROUBLESHOOTING
Possible Cause
Roller brush or sweeping tunnel
blocked by sweeping material.
Roller brush or side brush worn
or not set correctly.
Sealing rubber damaged by
foreign bodies or running over
obstacles without a ramp.
Roller Brush are not installed
according to their direction of
rotation.
Cause unclear.
Dust filter no longer cleaned.
Sealing rubber faulty, so that the
vacuuming system cannot work
properly.
Dirt-hopper is full.
Sealing section fastened wrongly
or faulty.
Sweeping tunnel blocked by
bulky sweeping material so that
no sweeping material can be
transported into the dirt-hopper
any longer.
Cause unclear.
Overload or wear of electrical
components or cause unclear.
Remedy
Check sweeping tunnel for
contamination or blockages and
remove them.
Check roller brushes and side
brushes for wear, readjust or
replace as required.
Check front, side and rear
sealing rubber for damage and
correct seating and replace as
necessary.
Remove the roller brush and fit
according to the direction.
Notify your dealer or customer
services.
Check, clean or replace dust filter.
Check front, side and rear sealing
rubber for damage and correct
seating.
Empty dirt-hopper.
Check sealing section on the filter
cover and replace as needed.
Remove contaminations or
blockages in the sweeping tunnel.
Notify your dealer or customer
services.
Notify your dealer or customer
services.
35