Ironing With Steam - Mx Onda MX-CPV2037C Manual De Instrucciones

Operating indicator of the water pump
Pressing the steam button 6, this indicator will light up and
the water pump will start working, steam coming out through
the holes in the sole of the iron.
Note: If the temperature selector is in the low temperature  SYNTETIC
position, even if the operating indicator of the water pump lights up, it
will not work as the temperature is not high enough to produce steam.
Steam flow regulation
Only when the temperature selector is in the position of average
temperature  WOOL SILK, high temperature  COTTON
or the maximum temperature MAX, you can obtain steam and
regulate the flow rate according to your preferences.
Turn the control clockwise to the position
it counterclockwise to the position
General switch on and off
Momentarily press this button to turn the steam station on or off,
when the button is pressed (
lit and when the button is not pressed (
will be off.
Note: The handle incorporates a safety switch, which shuts off the steam
station when the handle is raised, regardless of the position of the
general on / off switch.

IRONING WITH STEAM

Check that the water tank 1 is full, the anti-lime filter 3 is correctly fitted in
its housing and that the handle 2 is collected.
Plug the ironing center into a mains power socket
To turn on the iron press the main switch 14, the water tank will light
indicating that the ironing center is on.
Turn the temperature selector 7 to the position marked "SYNTHETIC",
"WOOL SILK", " COTTON" or "MAX
type of garment to be ironed, see the ironing guide in this manual.
The temperature indicator light 5 will light up until the temperature of the
sole of the iron reaches the selected temperature.
The ironing center will be ready when the temperature indicator light 5 goes
off for the first time.
to increase the steam flow or turn
to decrease or cancel the steam flow.
) the ironing center will remain
) the ironing center
9
", depending on the