Redarc TVMS Rogue Guia De Instalacion página 8

INSTALLATION — MOUNTING
When mounting the TVMS Rogue, any fasteners may be used so
long as:
ƒ They are suitable for the selected mounting surface and;
ƒ They have a clearance-fit through the mounting holes on the
Main Unit.
Using four screws/bolts from M6 (1/4") to M4 (#8) with washers is
recommended.
NOTICE: Do NOT modify the plastic housing or mounting holes in
any way. Modification to the unit will void the warranty.
MOUNTING LOCATION
ƒ Mount as close as possible to the auxiliary battery to avoid
voltage drop.
ƒ Do not mount the Main Unit to moveable panels in your vehicle.
ƒ Do not mount the Main Unit using adhesives or adhesive tape.
ƒ Mount the Main Unit permanently to a surface that has adequate
strength and structure to support it when all connectors and
wiring are in-place.
ƒ Mount in a location that is cool, i.e. avoid mounting in a full-sun
position or next to devices that emit heat. If the published thermal
ratings are exceeded, the TVMS Rogue may automatically turn
Off some or all outputs.
ƒ Mount in a location that is dry and is not prone to high humidity.
Liquid or vapour entering the Main Unit can cause irreparable
damage.
ƒ Mount in any orientation except with the connectors facing
upwards to prevent condensation/liquids running into the Main
Unit.
ƒ The mounting surface must be flat and safe to drill — check the
reverse side before drilling.
MOUNTING IN ENCLOSED SPACES
If installing TVMS Rogue in an enclosed space, make sure there is
adequate venting. Two vents should ideally be positioned at the top
and bottom of the enclosure for cross-flow of air.
Allow at least 50 mm (2") clearance on all sides of the Main Unit for
air flow.
8
SYSTEM CONFIGURATION
WARNING: When using the REDARC Configurator App, ensure
that you DO NOT configure important vehicle safety features (such
as lights or mechanical devices) in such a way that they may turn
Off/On unintentionally while the vehicle is in motion.
NOTICE
ƒ The Configurator App allows modification to the core functionality
of your RedVision system. Only use this app if you have read
®
and fully understand all instructions in this manual.
ƒ Ensure that the channel and master override switches are turned
Off after use to prevent accidental operation of the channel and
flattening of the Auxiliary Battery.
GET THE REDVISION CONFIGURATOR APP
®
Configure the settings of your TVMS Rogue using your smartphone
via Bluetooth .
®
The Configurator App and its interactions with
the TVMS Rogue have not been tested on all
smartphone models. Visit the application pages
within your App store to view compatibility details.
PAIR THE CONFIGURATOR APP TO THE DISPLAY
1. Make sure Bluetooth is enabled on your smartphone, then open
®
the Configurator App. Note, some smartphones also require
Location Services to be enabled.
2. On the RedVision Display, navigate to Display Settings.
3. Press the Bluetooth Soft Key (
®
Pairing Advertising screen.
4. In the Choose System screen in the App, select the system that
matches the number on the RedVision Display that you want to
configure.
5. Enter the Passcode shown on the Display into the input field,
then tap Pair.
Once the Display is successfully connected, the Configuration
Main Menu in the App will open.
EDIT A CONFIGURATION
1. Open the RedVision Configurator App.
®
2. From the Choose System screen, tap Open Configuration
3. From the list, choose the configuration you want to edit.
4. Edit the configuration as required to suit your RedVision system
— remember to tap Save
) to display the Bluetooth
each time you make a change.
.