Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Remove the spark plug boot and use a spark plug wrench to
remove the plug. See Figure 23.
2.
Visually inspect the spark plug. Discard the spark plug if there is
apparent wear, or if the insulator is cracked or chipped. Clean the
spark plug with a wire brush if it is to be reused.
3.
Measure the plug gap with a feeler gauge. Correct as necessary
by bending side electrode. See Figure 24. The gap should be set
to 0.030 in.
4.
Check that the spark plug washer is in good condition and thread
the spark plug in by hand to prevent crossthreading.
5.
After the spark plug is seated, tighten with a spark plug wrench to
compress the washer.
NOTE: When installing a new spark plug, tighten 1⁄2 turn after the
spark plug seats to compress the washer. When reinstalling a used
spark plug, tighten 1⁄8-1⁄4 turn after the spark plug seats to compress
the washer.
Warning
Never use gasoline or low flash point solvents for cleaning the air
cleaner element. A fire or explosion could result.
Servicing the air cleaner
The air cleaner prevents damaging dirt, dust, etc., from entering the
carburetor and being forced into the engine and is important to engine
life and performance. Never run the engine without an air cleaner
completely assembled. Check the air cleaner before each use.
Paper filters cannot be cleaned and must be replaced once a year
or every 100 operating hours; more often if used in extremely dusty
conditions.
1.
Loosen the screws that hold the air filter cover. See Figure 25.
2.
Open the cover and remove the pre-cleaner and air filter.
3.
Wash the pre-cleaner and allow to dry.
4.
Discard old air filter.
5.
Install new air filter and washed pre-cleaner.
6.
Close the cover and tighten the screws.
NOTE: If the filter is torn or damaged in any way, replace it.
caUTion
Do not spray engine with water to clean because water could
contaminate fuel. Using a garden hose or pressure washing equip-
ment can also force water into the muffler opening. Water that passes
through the muffler can enter the cylinder, causing damage.
Warning
Accumulation of debris around muffler could cause a fire. Inspect and
clean before every use.
cleaning the engine
If the engine has been running, allow it to cool for at least half an hour
before cleaning. Periodically remove dirt build-up from the engine.
Clean around the muffler. Clean with a brush or compressed air.
SERVICE AND MAINTENANCE
spark Plug
Electrode
0.02-0.03 in.
0.60-0.80 mm
air filter
Cover
19
spark Plug
Boot
Figure 23
Figure 24
Pre-cleaner
Figure 25
air
filter
Publicidad
