Publicidad
Idiomas disponibles
Idiomas disponibles
Model: 6138
REPLACING THE CONTROL KNOB'S PRINTED
CIRCUIT BOARD
If the control knob does not work, the PCB may need to be replaced�
Pull out the non-func-
STEP 01
tional control knob and set aside�
ob to
cian
Use a Philips head
STEP 02
screwdriver to remove the two
(2) M4x10 screws from the knob
bezel and set aside�
in
Remove the knob bezel
STEP 03
and set aside�
cian
lift out the knob PCB,
STEP 04
and disconnect the wire from the
back of the knob PCB�
dle� In
cian
all
Plug the connector into
STEP 05
the new knob PCB�
Reverse the above assembly
steps to reinstall the
control knob�
BLACKSTONEPRODUCTS.COM/SUPPORT
TROUBLESHOOTING
| OWNER'S MANUAL
17
Publicidad
