Descargar Imprimir esta página

Linea 2000 DOMO DO7298S Manual De Instrucciones página 79

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 95
CHARGING/EMPTYING STATION
37. Lid
38. Dust bag
39. Dust bag handle
40. Dust bag guide plate
41. Power supply cable
42. Indicator light
43. Vacuum port
44. Charging contacts
BEFORE THE FIRST USE
·
Put two AAA batteries in the remote control.
·
Set the time (see "use/use with remote control/ Clock settings").
·
Place the signed brushes on the vacuum cleaner. Press on them until you hear a click. The brushes and
the applience are marked with L (left) and R (right); make sure they match.
·
Install the charging/emptying station:
1. Place the charging/emptying station on a flat,
hard surface; allow at least 5 cm free space
behind the station and 1 m free space on
the left and right-hand sides. In front of the
charging station, there must be a free area of 2
m. If this is not the case, the robot vacuum may
not be able to find the station for charging or
emptying.
2. Install a dust bag in the charging/emptying
station (see "Replacing the dust bag").
3. Plug the charging/emptying station into the
wall socket. Make sure the power cable is not in
front of or next to the station. The charging/emptying station indicator light will flash slowly.
·
Allow the robot vacuum to charge fully for 12 hours before first use. See "Charging".
CHARGING
·
Switch on the robot vacuum machine using the power switch on the side of the machine.
·
Make sure the charging/emptying station is installed correctly (see above).
·
Press the home button on the appliance
emptying station and start charging.
www.domo-elektro.be
37
41
or remote control
. The robot will drive to the charging/
38
39
40
42
43
44
79
DO7298S

Publicidad

loading