Tineco FLOOR ONE S3 Serie Manual De Uso página 25

Filling Clean Water Tank
1.Press the Clean Water Tank release button to
remove it from the appliance.
Fig.C-4
2.Open the tank cap, and fill with tap water to
the Max line. When deep cleaning is necessary,
add one bottle cap of solution to the CWT and
tightly close the cap.
Fig.C-5
Note:
Only use water under 140°F/60°C.
DO NOT USE HOT WATER.
3.Place the tank back into the appliance. You
should hear a "Click" if done correctly.
Fig.C-6
Charging Instructions
To charge the appliance, place the appliance on
the charging dock and plug the adaptor into a
power outlet.
1.To charge the appliance, connect the external
charging cord to the charging dock and plug it
into the wall outlet.
2.To avoid tripping hazards, please place the
appliance on the charging dock near a wall
during charging.
Fig.C-7
Warning:
• Only charge the appliance with the adaptor
supplied by Tineco.
• During long periods of not being used, the
appliance must be charged once every 3
months for optimal performance. It may take
4-5 hours for a full charge.
• Store indoors in a dry place. Do not expose the
appliance to sunlight or freezing temperatures.
Recommended temperature range: 39.2°F
(4°C) ~ 104°F (40°C).
Cleaning Mode Selection
AUTO Mode
• In AUTO mode, the iLoop sensor automatically
detects how dirty the floor is and applies the
appropriate amount of detergent and suction
power.
• A red dirt monitoring loop indicates more dirt
is detected, and a blue loop indicates less dirt
is detected. This mode automatically provides
the best cleaning solution.
Fig.C-8
MAX Mode
• In AUTO mode, press the
MAX mode. The AUTO indicator on the display
will turn off.
• In MAX mode, the appliance will apply max
suction power and will spray water/solution for
deeper cleaning.
Fig.C-9
SUCTION Mode (only available in
selected models)
• In MAX mode, press the
SUCTION mode.
• In SUCTION mode, the appliance will only
absorb water and do not spray. We recommend
using this mode on the wet surface.
Fig.C-10
Note:
Keep sharp objects away from the digital display
screen to avoid scratches and scrapes.
Runtime
• When in AUTO mode, the runtime is
approximately 35 minutes. When MAX power is
used, the runtime is approximately 25 minutes.
• Estimated runtime data was obtained by a
Tineco Laboratory.
Charging Time
• A full charge takes approximately 4-5 hours.
• Estimated data was obtained by a Tineco
Laboratory using ambient temperatures
ranging from 39.2°F (4°C) to 104°F (40°C).
23
button to enter
button to enter