Tineco FLOOR ONE S3 Serie Manual De Uso página 27

Status
Deep cleaning
Self-cleaning
completed
Self-cleaning
stopped
Clean with cleaning
solution by default
Clean with water only Clean with water only
Auto mode by
default
Switch to Max mode Max Mode
Voice prompts on
Voice prompts
disabled
MAINTENANCE
Note:
• For optimal performance and to prevent odors,
always clean and dry DWT, floater, filters, brush
roller, brush roller cover completely after each
use.
• Please make sure each part is installed correctly
or the appliance may not work properly.
• After maintenance, place the appliance on
the charging dock vertically. Do not expose
the appliance to direct sunlight, and store it
indoors in a dry place.
Main Body
1.To reduce the risk of injury, switch off before
performing maintenance.
Fig.D-1
2.Use a cloth to clean the surface with a neutral
detergent. The cloth should be dry to prevent
water from entering the appliance.
Fig.D-2
3.Clean the dirt sensor with a damp cloth or the
cleaning tool.
Fig.D-3
Reminder
Deep cleaning
Self-cleaning cycle
complete. Please clean
Dirty Water Tank
Self-cleaning cycle
stopped. Please clean
Dirty Water Tank
Clean with cleaning
solution
Auto Mode
Voice prompts on
Voice prompts disabled
Dirty Water Tank
1.When dirty water reaches the Max line,
the appliance will stop working and show
a reminder on the display and play a voice
prompt.
2.Pull up the tank lid to empty the DWT. Use
the cleaning tool to remove remaining debris.
Rinse the inside of the DWT and place back
into the appliance.
Fig.D-4
Filter & Floater
1.If the filter and the floater have been blocked,
rinse with water.
2.Remove the filter from the tank lid, remove the
floater, and rinse both parts with water.
Fig.D-5
Dry Filter
Grasp recessed area on each side of the dry filter
and pull upward. Rinse under running water and
must be completely dry before recombining with
the lid of the DWT.
* A spare dry filter is provided with your
appliance for convenient replacement.
Fig.D-6
Brush Roller Self-cleaning
1.Place the appliance on the charging dock after
use, the sensor will auto-detect the level of dirt.
2.When you hear the voice prompt "please
begin self-cleaning cycle," press the self-
cleaning button and begin the process.
3.Once complete, you will hear the voice prompt
"self-cleaning completed, please clean the
Dirty Water Tank." At this point, the appliance
will begin charging.
Fig.D-7
Note:
• Ensure the charging dock is plugged in and the
battery level>10%.
• Before self-cleaning cycle, please clean
the DWT and ensure the water level in the
CWT>40%.
25