Publicidad
Idiomas disponibles
Idiomas disponibles
IW 1/2" 400 18-EC
Inserting/replacing the battery
■ Press the charged battery into the power
tool until it clicks into place (see figure B).
■ To remove, press the release button (1.) and
pull out the battery (2.) (see figure C).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short
circuit the contacts; explosion and fire hazard!
Removable belt clip
Your tool is equipped with a removable belt
clip 7 that can be positioned on the side of
the tool for convenient transport.
■ Remove the battery pack from the tool.
■ Align the rib and the hole of the belt clip 7
with the opening 8 and the threaded hole
on the base of the tool. (see figure D).
■ Insert the fastening screw 9 and securely
tighten the screw with a screwdriver (not
included).
Strap fixing
■ Strap fixing 6 is provided to attach a wrist
strap (not included) in order to reduce the
chances of dropping your tool. Wrap the
strip around your hand when carrying the
tool (see figure E).
Install and remove the impact
socket (see figure F)
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch 5
to the middle position.
Make sure that the impact socket and the
mounting portion are not damaged before
installing the impact socket.
■ Align the square of the impact socket with
the square drive 1 and push the impact
socket onto the square drive as far as it will
go.
■ Tap it lightly if required.
■ To remove the impact socket, simply pull it
off.
WARNING!
The impact socket may be hot after prolonged
use. Use protective gloves when removing
the impact socket from the tool, or first allow
the impact socket to cool down.
Direction preselection (see figure
G)
CAUTION!
Change the direction of rotation only when
the power tool is stopped.
Move the direction preselector switch 5 to the
required position:
■ Position the direction preselector switch to
the far left of the tool to tighten bolts/nuts
■ Position the direction preselector switch to
the far right of the tool to loosen bolts/nuts.
■ Position the direction preselector switch
in the "OFF" (center-lock) position to help
reduce the possibility of accidental starting
when not in use.
NOTE
The impact wrench will not run unless the
direction preselector switch is engaged fully
to the left or to the right.
WARNING!
Battery tools are always in operating condition.
Therefore, the direction preselector switch
should always be locked in the center position
when the tool is not in use or when carrying it
at your side.
Mode selection (see figure H)
Your tool is equipped with a speed control
panel 3, located on the foot of the tool. It
consists of the drive-control button, the
"M" button, and LED indicators for working
modes.
The drive-control button is used to select
among three modes to adjust the torque,
rotation-speed (RPM), and impact-speed (IPM)
setting for an application. The modes 1, 2,
and 3 are the only modes where the speed
is controlled by the variable-speed trigger
switch.
To select the drive control mode:
■ First, check the active mode. Press the drive
control button directly without touching the
trigger switch. The LED indicator below the
mode number will illuminate to indicate the
active mode setting.
■ Press the drive-control button briefly (less
than 0.5 second) to cycle through the 3
modes. Each press changes one torque
level. See more details in the chart below.
15
Publicidad
