Publicidad
Idiomas disponibles
Idiomas disponibles
1. Connect one end of handset coil cord to the handset jack
2. Connect the other end of the coil cord to the jack on the base unit (please, refer to the Key Diagram on page 16,
marked as 5. )
3. Connect one end of the line cord to the wall oulet .
4. Connect the other end of the line cord to the jack on the base unit (please, refer to the Key Diagram on page
16, marked as 12. )
5. At this moment, once you lift the handset from the cradle, you should have dial tone and you will be able to
make/receive calls.
Wall mounting
This telephone set can be mounted on wall. Please, use the wall mounting pattern from the Annex A of this manual.
To prevent the handset from falling, take the handset guide out (please, refer to the Key Diagram on page 15, marked
as 5). You can use the curve area of a paper clip to take it out, to avoid scratching the unit. Once you have taken
this piece out, rotate it 180º and then reinsert it in the original place.
INSTALLATION AND START UP
17
Publicidad
