Nexigo PJ40 Manual Del Usuario página 33

Q: HOW CAN I USE THE FIRE TV REMOTE TO CONTROL PJ40?
A: To achieve this, follow these two steps:
1. Set the Power-on Source to the HDMI port connected to Fire TV in
Settings - System - Power-on Source.
2. Configure the remote in Fire TV settings: Settings - Equipment
Control - Manage Equipment - TV - Infrared Options - IR Profile -
Change IR Profile - Find IR Profile and Enter the IR Profile Number:
4737.
3. Now you can use the Fire TV remote to control PJ40.
FCC REQUIREMENT
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
EN 32