Nexigo PJ40 Manual Del Usuario página 4

Please do not open or disassemble the projector, as this may result
in an electrical shock.
Do not attempt to service the unit yourself. Opening the unit may
expose you to dangerous voltages and/or other hazards. The unit
should only be repaired by the manufacturer or its service agent.
Only use attachments/accessories directly specified by the
manufacturer.
Do not look straight into the projector lens during operation.
Excessively bright lighting has been shown to harm vision under some
circumstances.
When switching the projector off, please ensure the cooling cycle
has been completed before disconnecting the power. Allow at least
90 seconds for the projector to cool down.
Do not use a power source with a voltage other than what is specified
in this manual.
Disconnect the power plug from the AC outlet if the product is not
being used for a long period of time.
Do not set up the projector in areas where it might be subjected to
vibration or shock.
Do not touch the lens with your bare hands.
Remove the battery/batteries from the remote control before storage.
If the battery/batteries are left in the remote for a long period of time,
they may leak.
Do not use or store the projector in places where smoke may be
present, as it can negatively affect the quality of the projector's
performance.
Please refer to the manual for how to properly install your projector,
as nonstandard installation may affect the projector's performance.
Use a power strip and/or surge protector with this device. Power
outages and/or brownouts can damage your device.
When installing or adjusting a ceiling or wall mount, do not use
adhesives, oils, and/or lubricants. These may cause the projector case
EN 03