Hach ORBISPHERE 410 Manual Básico Del Usuario página 7

4.3 Panel mounting
Electrocution hazard. If the cable and connector for the power supply are not accessible after
installation, an accessible local disconnection means for the instrument power is mandatory.
1-3
1. Cut an opening in the panel to accommodate the bracket frame provided.
2. Install the provided frame in the opening.
3. Fold the 6 tabs over the panel lips, using adjustable joint pliers.
4. Slide the instrument in the bracket frame. The instrument should go over the four "T" pins. Rotate the 4 fast
locking screws on both sides of the front panel and slide it in.
5. Rotate the 4 fast locking screws 1/4 turn twice in the lock direction as indicated on the side of the front panel.
This locks the instrument in place on the four "T" pins.
6. To access the connections inside the instrument, remove the instrument housing (six screws on the back
panel, and slide the housing back out)
7. Pass the cables through the housing, then through the cable gland (if applicable) and then perform the
connections as detailed below.
4.4 Instrument connections
Figure 1 Connections - wall/pipe (left); panel (right)
1 Power cable
2 USB-B 4-pin connector
3 Ethernet cable gland
4 Sensor connection
W A R N I N G
4-5
5 USB-A host connector
6 Input/Output 2 cable gland
7 Input/Output 1 cable gland
8 Keylock (wall/pipe mount only)
6-7
English 7