Publicidad
Idiomas disponibles
Idiomas disponibles
INOXPAN S.L.
5.1.5. SHELVES AND STORAGE
WARNING: Do not pull out more than one full shelf at once, as this could cause the unit tip
forwards. Some shelves are designed to store more than one layer of bottles. These shelves
should not be slid out if there is more than 1 layer of bottles on them.
WARNING: Do not attempt to slide the shelves out further than the stop position, to avoid
bottles falling.
WARNING: To avoid damage to the door seal, make sure that the door is completely open
when you pull a shelf out of the compartment.
• All the shelves slide, for easy access, except the bottom shelf. To access the bottles easily,
pull the shelf out gently until it stops. The shelves are designed with an emergency stop to
prevent them coming out too much while the bottles are being loaded.
• You can store your bottles in a single row or stacked, taking the following into account: If you
do not have enough bottles to fill the cabinet, it is better to distribute them, so as to avoid
them being all at the top or all at the bottom.
• Do not remove or change the wooden shelves to make room for larger bottles or to increase
the capacity by piling them all up. (See removing shelves)
• Maintain a small space between the walls of the cabinet and the bottles to allow for air
circulation. Like in an underground cellar, air circulation is important to avoid mold and
maintain a more homogenous temperature.
• Do not overload the cabinet, to facilitate air circulation.
• Place the bottles flat.
• Avoid obstructing the internal fans (located inside the rear panel of the unit)
• Do not place any contaminants inside. Only store beverage in your unit, to guarantee an
environment free from smells.
• Only store unopened bottles. Storing opened bottles could give rise to spills.
124
BEVERAGE COOLER
Publicidad
