Pando integralCooking 10258 Manual De Uso E Instalación página 132

INOXPAN S.L.
7. TROUBLESHOOTING
Many common problems are easy to solve, avoiding a call to the technical service.
Try the following suggestions to solve the problem before calling the customer/after sales service.
PROBLEM POSSIBLE CAUSE
• Appliance is not connected to a power supply.
The unit does
not work.
• The appliance is turned off.
• Circuit breaker has tripped or a fuse blown.
• The temperature has not been correctly set.
The unit does
not cool enough.
• Ambient
temperature setting.
• The door is opened very frequently.
• The door is not completely closed.
• The door does not close hermetically.
• The condenser is too dirty.
• The ventilation opening is obstructed or contains
too much dust.
• Ambient temperature is higher than average.
The unit turns
on and off
• Many bottles have just been added to the unit.
frequently.
• The door is opened very frequently.
• The door is not completely closed.
• The door does not close hermetically.
The light does •
The unit is not connected to the mains.
not come on.
•
Circuit breaker triggered / ICP or fuse burnt out.
•
The light was switched off from the front panel.
Vibrations. • The unit is not exactly level.
The appliance
The rattling noise may come from the flow of the coolant, this is normal. At the end of each cycle,
makes noises.
you may hear gurgling noises made by the flow of coolant in the appliance. If there are temperature
fluctuations, contraction and expansion of internal walls may make cracking noises.
• The unit is not exactly level
• The door opening side was changed and it has
The door does
not close
not been correctly fitted.
correctly.
• The seal is dirty.
• The shelves are incorrectly positioned.
• The appliance is not properly levelled.
temperature requires
• Connect the unit.
• Switch on the unit.
• Reset the circuit breaker / ICP or change the
burnt-out fuse.
• Check the temperature setting
• Select a higher temperature.
a higher
• Do not open the door unless strictly
necessary.
• Close the door with care.
• Check the door seal and clean or replace it.
• Clean the condenser when necessary.
• Remove obstructions and clean out the dust.
• Place the appliance in a cooler location. Let
the appliance work for a time until it has
reached the selected temperature.
• Do not open the door unless strictly
necessary.
• Close the door with care.
• Check the door seal and clean or replace it.
• Connect the unit.
• Reset the circuit breaker / ICP or change the
burnt-out fuse.
• Switch on the light using the front panel.
• Level the unit using the adjustable feet.
• Level the unit using the adjustable feet.
• Check the door seal and refit correctly.
• Clean the door seal.
• Check the shelves and refit correctly.
• Level the appliance with the adjustable feet.
132
BEVERAGE COOLER
SOLUTION