Extension Shaft - IKRA BAS 3018 Instrucciones De Manejo

The pruner's saw chain cannot be locked in place
on the guide bar. Therefore, it is best to remove the
chain from the bar and resharpen it on a workshop
sharpening tool.
• Select the appropriate sharpening tools for the chain
pitch. See „Specifications" for the permitted chain
pitches.
The chain pitch (e.g. 3/8") is marked on the depth gauge
of each cutter.
Use only special saw chain files!
Other files have the wrong shape and cut.
Select the file diameter according to the chain pitch.
You must also observe the following angles when re-
sharpening the chain cutters.
A = Filing angle
B = Side plate angle
Furthermore, the angles must be the same on all cutters.
If angles are uneven the chain will run roughly, not in a
straight line, wear quickly and break prematurely.
As these requirements can be met only after sufficient
and constant practice:
• Use a file holder
A file holder must be used for manual resharpening of
saw chain. The correct filing angles are marked on the
file holder.
• Hold the file guide bar) and file according to the angles
marked on horizontally (at right angle to side of the
file holder. Rest the file holder on the top plate and
depth gauge.
• Always file from the inside to the outside of the cutter.
• The file only sharpens on the forward stroke – lift the
file off the cutter on the backstroke.
• Avoid touching the tie straps and drive links with the
file.
• Rotate the file at regular intervals while filing to avoid
one-sided wear.
• Use a piece of hardwood to remove burrs from cut-
ting edge.
All cutters must be the same length. If the cutters are not
the same length, they will have different heights. This
makes the chain run roughly and increases the risk of
breakage of the chain.
4. 706 MM EXTENSION SHAFT
To reach a high position, you can add an extension shaft
between the main body and add-on attachment.
When use hedge trimmer or chain saw to cut high
branches, the falling twigs and saw dust may hurt youe
face and hands. Always wear helmets with visor and pro-
tective gloves to prevent damage to your view and skin.
Tight fitting clothingand safety boots should also be worn
to prevent injury.
GB-17