Makita 6041D Manual De Instrucciones página 7

Removing built-in battery
CAUTION:
•
Never remove the built-in battery from the tool
except when disposing of the tool. The battery will
be damaged or a battery short-circuit could result.
To remove the cover, push it in the direction of the arrow
while pressing down on the "OPEN" portion of the cover.
Withdraw the built-in battery halfway. Disconnect the two
lead wires from the battery by pulling them from the bat-
tery terminals. Then withdraw the battery completely.
1
To prevent a battery short-circuit, tape the battery termi-
nals or put the battery into a plastics bag. (Note: Never
put two or more batteries into one plastics bag. Battery
short-circuit may result.)
CAUTION:
•
Never incinerate the battery even if it is severely
damaged or is completely worn out. It can explode
in a fire or toxic materials can leak out of it.
Ni-Cd
Recycling the Battery
The only way to dispose of a Makita battery is to recycle
it. The law prohibits any other method of disposal.
To recycle the battery:
002144
1. Cover
1
002145
1. Battery terminal
2. Lead wire
3. Battery
2
3
1.
Remove the battery from the tool.
2. a)
Take the battery to your nearest Makita Fac-
tory Service Center
or
b) Take the battery to your nearest Makita
Authorized Service Center or Distributor that
has been designated as a Makita battery
recycling location.
Call your nearest Makita Service Center or Distributor to
determine the location that provides Makita battery recy-
cling. See your local Yellow Pages under "Tools-Electric".
ACCESSORIES
CAUTION:
•
These accessories or attachments are recom-
mended for use with your Makita tool specified in
this manual. The use of any other accessories or
attachments might present a risk of injury to per-
sons. Only use accessory or attachment for its
stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Drill bits
• Screw bits
MAKITA LIMITED ONE YEAR WARRANTY
Warranty Policy
Every Makita tool is thoroughly inspected and tested
before leaving the factory. It is warranted to be free of
defects from workmanship and materials for the period of
ONE YEAR from the date of original purchase. Should
any trouble develop during this one year period, return
the COMPLETE tool, freight prepaid, to one of Makita's
Factory or Authorized Service Centers. If inspection
shows the trouble is caused by defective workmanship or
material, Makita will repair (or at our option, replace)
without charge.
This Warranty does not apply where:
• repairs have been made or attempted by others:
•
repairs are required because of normal wear and
EN0001-1
tear:
• the tool has been abused, misused or improperly
maintained:
•
alterations have been made to the tool.
IN NO EVENT SHALL MAKITA BE LIABLE FOR ANY
INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAM-
AGES FROM THE SALE OR USE OF THE PRODUCT.
THIS DISCLAIMER APPLIES BOTH DURING AND
AFTER THE TERM OF THIS WARRANTY.
MAKITA DISCLAIMS LIABILITY FOR ANY IMPLIED
WARRANTIES, INCLUDING IMPLIED WARRANTIES
OF "MERCHANTABILITY" AND "FITNESS FOR A SPE-
CIFIC PURPOSE," AFTER THE ONE YEAR TERM OF
THIS WARRANTY.
7
EN0006-1