Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
Remote Control:
The Heater can be completely controlled by the remote. One
CR 2025 3V battery is needed (Battery not included).
WARNING:
• Danger of explosion if battery is incorrectly replaced.
• DO NOT INGEST BATTERY; CHEMICAL BURN HAZARD
• This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe
internal burns in just 2 hours and can lead to death.
National Battery Ingestion Hotline (800) – 498-8666.
• Keep new and used batteries away from children. If the
battery compartment does not close securely, stop using
the product and keep it away from children.
• If you think batteries might have been swallowed or placed inside any part of the
body seek immediate medical attention.
• If the coin cell battery contents come into contact with the skin, immediately wash
area with mild soap and water. If coin cell battery liquid gets into the eye, rinse
water over the open eye for 15 minutes or until irritation ceases. If medical attention
is needed, the battery electrolyte is composed of an organic solvent and lithium
salts.
• Do not incinerate or dispose of tool together with household waste material! Tool
that has reached the end of its life must be collected separately and returned to an
environmentally compatible recycling facility.
Installing the Battery:
1. Using a small Phillips Head screwdriver, remove the screw by turning counter-clockwise
until it releases from the remote.
2. Push the button at the base of the battery cover to release the cover. Pull out the
battery cover as shown in the diagram.
3. Insert the battery making sure the "+" side is facing up.
4. Once the battery is installed, push the battery cover closed.
5. Again, using the small Phillips Head screwdriver, add the screw back by turning
clockwise until it is locked in place.
Phillips Head screwdriver
Remote Control Battery Cover
Battery
PULL
PUSH
Page 9
Publicidad
