Publicidad
Idiomas disponibles
Idiomas disponibles
Before connecting a water supply hose, be sure the water supply is capable of providing an
uninterrupted source of clean, cold water at a minimum rate of 5 gallons per minute (GPM)
and 20 pounds per square inch (PSI) of pressure. Once a proper water supply is secured,
follow the instructions below to connect both the water supply and high-pressure hoses to
the pressure washer.
1.
Turn on the water
supply and run for 30
seconds to purge any
debris from the supply
hose. Then, turn off the
water supply and thread
the water supply hose
into the pump inlet filter.
2.
While pulling back on the pump outlet collar,
insert the high-pressure hose connector
then release the collar. Gently tug on the
high-pressure hose to make sure it is locked.
3.
While pulling back on the high-pressure hose outlet collar, insert the
spray gun connector then release the collar. Gently tug on the hose to
make sure it is locked.
Page 10
CONNECTING HOSES
Publicidad
