Publicidad
Idiomas disponibles
Idiomas disponibles
Follow the steps outlined in this section to unpack and assemble your pressure washer.
If you have any questions regarding the unpacking or assembly of your pressure washer,
please have your model number and serial number ready, then contact customer support at
1-877-362-4271 or email cservice@fna-group.com.
1. Place the shipping carton on a solid, flat surface.
2. Carefully cut the top of the carton open.
3. Carefully cut each corner of the carton from top to bottom.
4. Lay each side of the carton flat on the ground.
5. Remove the contents of the carton.
Install knob-style handle
Slide the handle onto the frame then secure
it with the included knobs and bolts.
Adding the pump breather cap
A RED shipping plug is in the pump that must be replaced with a BLACK breather cap.
The plug is easy to replace with the following steps:
1.
Using a bladed screw driver, remove the RED shipping plug from the top of the pump.
2.
Hand thread the BLACK breather cap into the pump.
3.
Snug the cap with your fingers.
RED shipping plug
Page 7
UNPACKING
ASSEMBLY
(if applicable)
BLACK breather cap
Publicidad
