Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Water Inlet Filter
Before each use, check the inlet filter and clean by following the steps below. Never operate
the pressure washer without the inlet filter properly installed.
1. Grip the filter housing as shown;
twist counterclockwise to remove.
2. Connect the housing to the garden
hose; turn on the water to flush.
3. Once the housing is free of debris, turn the water off.
4. Disconnect the garden hose from the filter housing.
5. Reconnect the filter housing to the pump by threading it in clockwise until snug. Do not
use a wrench or other means of mechanical tightening, the housing could break.
Page 23
Publicidad
Tabla de contenido
