Orascoptic SPARK Serie Instrucciones De Uso Y Mantenimiento página 9

Mounting Your Spark Headlight (through-the-lens) to an Orascoptic Loupe
The Spark headlight is secured to an Orascoptic-branded loupe by tightening the mounting screws directly
into the frame bridge.
1. If your Orascoptic loupe has a badge on the frame bridge, carefully remove it to reveal two threaded
mounting holes.
2. Push two mounting screws through the mounting clip and use an optical screwdriver to slightly
tighten both screws into the frame.
3. Center the device over the bridge of your loupe frame and tighten the mounting screws until it is secure.
4. If the light is not centered in your field of vision, you may need to loosen and adjust the mounting clip
left or right as needed. Once centered in your field of view, retighten the mounting screws
until the device is secure.
INSTRUCTIONS FOR USE AND CARE
See back cover for Customer Care or Technical support contact information | Customers outside our direct sales regions, contact your local distributor
™ ™
Orascoptic Spark Series Headlight
Orascoptic Bridge Plate badge must
be removed to access mounting holes
9