IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
When cleaning surfaces of door and appliance that
▶
come together on closing the door, use only mild, non-
abrasive soaps, or detergents applied with a sponge or
soft cloth. See door surface cleaning instructions.
WARNING
Do not repair, replace or remove any part of the appliance
unless specifically recommended in the manuals.
Improper installation, service or maintenance can cause
injury or property damage.
Refer to this manual for guidance.
▶
▶
All other servicing should be done by an authorized
service provider.
Never modify or alter the construction of the appliance.
▶
For example, do not remove leveling legs, panels, wire
covers or anti-tip brackets/screws.
WARNING
Remove all tape and packaging before using the
appliance.
▶
Dispose of packaging in an environmentally responsible
manner.
▶
Never allow children to play with packaging material.
CAUTION
For general ventilating use only.
▶
To avoid a fire or explosion hazard, do not use to
exhaust hazardous or explosive materials and vapors.
WARNING
Do not operate gas cooktop burners without pots in place.
The open flame may overheat the appliance above.
To reduce the risk of fire, use only metal ductwork.
This appliance is suitable for use above gas or electric
cooking equipment 36" (914 mm) or less wide.
2.4 Appliance handling safety
WARNING
Unit is heavy and requires at least two people or
proper equipment to move.
Do not lift appliance by door handle.
▶
WARNING
Hidden surfaces may have sharp edges.
▶
Use caution when reaching behind or under appliance.
SAVE THESE INSTRUCTIONS.
2.5 Safety codes and standards
This appliance complies with the latest version of one or
more of the following standards:
¡ CAN/CSA C22.2 No. 150 - Microwave Ovens
¡ CAN/CSA C22.2 No. 61 - Household Cooking Ranges
¡ CSA C22.2 No. 64 - Household Cooking and Liquid-
Heating Appliances
¡ UL 1026 - Electric Household Cooking and Food
Serving Appliances
¡ UL 923 - Microwave Cooking Appliances
¡ UL 858 - Household Electric Ranges
¡ UL 507 - Electric Fans
¡ CAN/CSA C22.2 No. 113 - Fans and Ventilators
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
2.6 Electrical safety
¡ Installer - show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
¡ If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
¡ Local codes vary. The installer is responsible for
ensuring that the installation, connections, and
grounding comply with all applicable codes. The
manufacturer is not responsible for improper installation
or the failure to follow appropriate local codes and
regulations.
¡ Be sure your appliance is properly installed and
grounded by a qualified technician. Installation,
electrical connections and grounding must comply with
all applicable codes.
¡ Refer to the rating plate for more information.
→ "Rating plate location", Page 16
WARNING
Before installing, turn power OFF at the service panel.
▶
Lock service panel to prevent power from being turned
ON accidentally.
The appliance must be disconnected from the source of
supply before attempting the installation.
For appliances equipped with a cord and plug, do not cut
or remove the ground prong.
▶
It must be plugged into a matching grounding type
receptacle to avoid electrical shock.
en-us
5