cecotec DRUMFIT INDOOR 24000 MAGNETIC CONNECTED Manual De Instrucciones página 25

ENGLISH
1. PARTS AND COMPONENTS
Parts list. Fig. 1
NUMBER PART
1 Handlebar
2 Handlebar nut
3 Handlebar bolt S1 (pre-assembled)
4 Handlebar stem
5 Main frame
6 L-shaped adjustment knob M1
7 Stabiliser cap nut
8 Front stabiliser
9 Allen bolt T1
10 Saddle
11 Saddle adjustment bracket
12 Saddle post
13 Adjustment knob
14 Pedal (set)
15 Rear stabiliser
16 Fixed spanner
17 Allen key
18 Stabilisers washer
NOTE:
the graphics in this manual are schematic representations and may not exactly match the
device.
NOTE: the screws, nuts and washers of the stabilisers are larger than those of the handlebar.
48 DRUMFIT INDOOR 24000 MAGNETIC CONNECTED
AMOUNT
1
4
4
1
1
2
4
2
4
1
1
1
1
1
2
1
1
4
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- DrumFit Indoor 24000 Magnetic Connected indoor bike
- Instruction manual
- Assembly kit
- 2 AA console batteries
3. ASSEMBLY
Step 1
Place the front (8) and rear (15) stabilisers on the main frame (5).
The nuts (7), stabilisers washers (18) and the Allen bolts (9) are pre-fixed to the stabilisers.
Remove them with the fixed spanner (16) and replace them as shown in the figure.
Caution: the front stabiliser is the one with the transport wheels. Fig. 2
Step 2
Put the L-shaped adjustment knobs.
Fit the adjustment knobs (6) in the holes provided on the main frame (5). To fix them in place,
turn them clockwise several times. You do not need any tools. Fig. 3
Step 3
Place the pedals (14) on the cranks and secure them using the fixed spanner (16).
Caution: The right pedal is marked with the R letter; the left one, with the L letter. Make sure
you place them on the correct side.
The right pedal is screwed in by turning clockwise and the left pedal counterclockwise. Fig. 3
ENGLISH
DRUMFIT INDOOR 24000 MAGNETIC CONNECTED 49