Cembre SD-36B Manual De Uso Y Mantenimiento página 9

clips, coin, keys, nails, screws or other small metal objects, that can make a connec-
tion from one terminal to another. Shorting the battery terminals together may cause
burn or a fire.
d) Under abusive condition, liquid may be ejected from battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause irritation or burns.
e) Do not use a battery pack or tool that is damaged or modified. Damaged or modified
batteries may exhibit unpredictable behaviour resulting in fire, explosion or risk of injury.
f ) Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire
or temperature above 130° C may cause explosion.
g) Follow all charging instruction and do not charge the battery pack or tool outside
temperature range specified in the instruction. Charging improperly or at temperatures
outside the specified range may damage the battery and increase the risk of fire.
6) Service
a) Have your power tool serviced by a qualified repair person using only identical repla-
cement parts. This will ensure that the safety of the power tool is maintained.
b) Never service damaged battery packs. Service of the battery packs Should only be
performed by the manufacturer of authorized service providers.
7) Drill safety warnings
Safety instructions for all operations
a) Hold the power tool by insulated gripping surfaces when performing an operation
where the cutting accessory may contact hidden wiring or its own cord. Cutting acces
sory contacting a "live" wire may make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
Safety instructions when using long drill bits
a) Never operate at higher speed than the maximum speed rating of the drill bit. At hi-
gher speeds, the bit is likely to bend if allowed to rotate freely without contacting the
workpiece, resulting in personal injury.
b) Always start drilling at low speed and with the bit tip in contact with the workpiece.
At higher speeds, the bit is likely to bend if allowed to rotate freely without contacting the
workpiece, resulting in personal injury.
c) Apply pressure only in direct line with the bit and do not apply excessive pressure.
Bits can bend, causing breakage or loss of control, resulting in personal injury.
9