Designers Fountain STELLANT Instrucciones De Instalación página 8

INSTALLATION (CONTINUED)
3
ASSEMBLE THE MOTOR AND ROD
NOTE: Rotate the center of the motor as
needed to access the arm screws
(EE).
 Remove the all the arm screws (EE)
from the motor (M) and set them aside.
Discard the plastic motor blocks if they
are installed with the arm screws (EE).
 Loosen the motor set screws (L) on the
top of the motor (M).
 Pull the wires from the motor (M)
through the center of the rod (F).
 Twist the rod (F) onto the motor (M)
until it is tight, and then unscrew the rod
(F) slightly until the holes in the rod (F)
and the holes on the motor (M) align.
 Insert the clevis pin (G) through the
holes the motor (M) and rod (F), and
then secure it with the cotter pin (H).
 Tighten the motor set screws (L).
4
ASSEMBLE THE TOP
 Thread the wires through the motor
cover (K), the canopy cover (J), the
canopy (I), and hanger ball (E).
 Push the motor cover (K) down the
rod (F) to cover the screws on the
motor (M).
 Insert the straight pin (C) into the
top of the rod (F), and push the
hanger ball (E) up so it locks with
the straight pin (C).
 Tighten the ball set screw (D) on
the hanger ball (E).
G
L
C
D
I
J
K
M
8
Plastic
Motor Block
E
F
F
H
M
EE