AquaTru ATU100 Manual Del Propietário página 10

RO Faucet Installation
ST EP
4
The RO faucet may be installed on any flat surface.
Check the underside of your install location for
interference by making sure that drilling a hole will
not damage any pipes or wiring underneath the
countertop of the sink. Check to be sure there is
enough room for the threaded faucet stem and nut.
Note:
For drilling, you must use an appropriate drill
bit and drilling method for the material of your sink
and or countertop. Different drill bits are required for
stainless steel, porcelain, marble, etc.
You may use an existing hole in your counter or sink
or drill a new hole (if using an existing hole begin at
step 2). Make sure the faucet decoration plate and
nut plate are big enough to cover the hole you use.
1. Drill a 20 mm hole using an appropriate drill bit
and drilling method for the material.
2. Remove the plastic nut from the threaded
faucet stem.
3. Insert the threaded faucet stem though the
newly drilled or pre-existing hole, making sure the
decorative plates and clear gasket stay on the
threaded stem and that they completely cover the
hole when installed.
4. Under the sink, install the plastic nut on the
threaded faucet stem, making sure the gasket
that comes with the fitting is seated inside
the fitting. Hand tighten it. Make sure the
faucet does not move and the top decorative
plate covers the hole.
5. Install the RO faucet quick connect fitting to the
threaded stem. First, wrap plumber's tape around
the thread. Make sure the clear washer is fully
seated inside the quick connect fitting. Screw the
fitting onto the threaded stem. Hand tighten with
an adjustable wrench. Do not overtighten.
9
Under Sink / Instructions
RO water
faucet
RO faucet quick
connect fitting
Clear plastic washer
Decorative plate &
clear gasket
Nut
Threaded faucet
stem
30 cm
13 cm