AquaTru ATU100 Manual Del Propietário página 9

Drain Saddle Installation
ST EP
3
Mark the position of the hole on the drain pipe and
drill a 6 mm hole through one side of the drain pipe.
There is a piece of self-adhesive sponge provided.
Glue this sponge to the inside of the saddle, this will
cushion any gap between the saddle and the pipe.
Make sure the hole on the sponge is thoroughly
punched out, and align it to the hole in the saddle.
Take the half side of the saddle without the foam and
insert a nut into the recess on each side.
Position both halves of the saddle on the drainpipe
with the saddle's opening aligned over the drilled
hole. The foam gasket will be between the drain
saddle and the drilled hole.
Tip: To ensure the hole on the drain saddle is
aligned with the hole in the drain pipe, insert the
drill bit into the drain saddle and use the drill bit
to align the two holes as you assemble the drain
saddle onto the drain pipe.
Secure the drain clamp halves together in place on
the drain pipe. Screw bolts through the drain clamp
half with the foam gasket and the other half with
the two nuts installed. Do not over tighten. When
tightening the bolts, make sure there is equal space
on both sides between the drain saddles.
Under Sink / Instructions
Foam gasket
Bolt
Drain pipe
Self-adhesive
sponge
6 mm
Hole
Nut
Drain
clamp
8