Publicidad
Idiomas disponibles
Idiomas disponibles
System Maintenance
ST EP
9
Filter Change:
The RO system contains three filters that must be replaced at regular intervals to maintain performance.
Use only genuine AquaTru filters. The three filters are:
·
·
Pre-Filter (AT2001) should be replaced every 6 months or every 2270L, whichever comes first.
VOC Filter (ATU2003) is replaced every 12 months or every 1360L, whichever comes first.
When replacing this filter we recommend that you also sanitize the holding tank.
·
See Sanitize RO holding tank before proceeding.
RO Filter (AT2002) is replaced every 24 months or every 4540L, whichever comes first.
When replacing this filter, we recommend that you also sanitize the holding tank.
·
See Sanitize RO holding tank before proceeding.
Optional VOC Carbon with PH+ Mineral Boost Filter (ATU2004) is replaced every 12 months or 1360L,
whichever comes first.
Sources of supply for replacement components:
Tips before you start:
1.
Ensure the service area is free of any excess dirt or dust in order to not cross contaminate parts.
2. Wash hands with soap and water and/or wear sanitary gloves.
How to Change Your Filters
1.
Turn off the cold water supply line.
2. Empty the RO holding tank by opening the RO water faucet.
3. Remove the filter to be replaced.
Helpful Hint: The filter can pivot out of the base to make it easier to unscrew.
4. Install the new filter, making sure that the filter is fully installed.
Helpful Hint: Write the date of filter installation with a permanent marker on the filter body,
or use our helpful Filter Replacement Records chart on the last page of this manual, so you can
easily identify when to replace the filters.
5. Close the RO water faucet.
6. Open the cold tap water supply line.
CHECK FOR LEAKS!
7.
After the RO holding tank has been completely filled, empty it to flush out the filter before consuming.
8. Refill the RO holding tank.
Under Sink / Maintenance
Aquatruwater.eu / Aquatru.co.uk
14
Publicidad
