Publicidad
Idiomas disponibles
Idiomas disponibles
2. CLASSIC PROGRAMMING (2 PEOPLE)
The programming of the monitor must be done from the main entrance panel of the
system (See the corresponding installation manual).
The button / programming code is stored in the monitor. If the monitor is replaced, do
not forget to program it.
For installations with several devices (telephones or monitors) in the same apartment,
first connect all the phones and monitors in said apartment and program them one
by one and with the same button or call code.
Programming steps
1. Move the PROG switch to the OFF position; Return the switch to the
ON position.
2. Wait for the door open button
press it and communication between the monitor and the main board
will be activated.
3. Located on the main street panel, make the call to the apartment
where the monitor to be programmed is located. The entrance panel
will emit a confirmation beep, the monitor has been programmed.
1
1
2
Note: Once the monitor is programmed, make sure that the PROG switch is in the
ON position.
Note: Maximum time of 1 minute between steps 1,2 and 3. After the maximum time
you must start programming from step 1.
VIDEODOOR ENTRY SYSTEM MONITOR
2
OFF
ON
to illuminate. When this happens,
3
ENG - 17
Publicidad
