Publicidad
Idiomas disponibles
Idiomas disponibles
ENG
Keys 9 & 10: There are for point to multipoint functionality. It is possible to use up to 4 cameras with
one dvr. Configure the DIP switches as follows:
1. From dvr / PC / switch, switches 9 and 10 should remain up.
2. From the camera, select one of the 4 configurations for switches 9 and 10:
Camera 1: 9 lowered and 10 lowered
Camera 2: 9 lowered and 10 raised
Camera 3: 9 raised and 10 lowered
Camera 4: 9 raised and 10 raised
3. Switch settings between cameras cannot be duplicated for buttons 9 and 10 or interference may
be caused, up to 4 points.
Remarks:
1. Restart the AP after finishing the DIP settings.
2. The default SSID of the AP type DIP is not transmitted, the password has been set and can be
customized.
3. Make sure the IP address of the camera is different from that of the AP Point to Multipoint, as
following picture:
Transmitter
Receiver
Note: For a single point-to-point case, it doesn't matter which slot you use. Just make sure that the
Working mode key and Matching key are set correctly.
5
Publicidad
