Publicidad
Idiomas disponibles
Idiomas disponibles
Q8: After connecting the AP to the NVR, I am able to see the IP address of the camera, but no image.
A8: Try changing the LAN port of the AP. If you are still having problems contact your dealer.
Q9: What do the LEDs on the device represent?
A9: Red: PWR: Power LED: it is on when the device is connected to the power supply.
Blue: WLAN: Wifi signal LED. It is on when Wifi is active.
LAN1, LAN2, are on when the device is working.
Orange: wireless signal strength.
First LED lit: very weak signal.
First and second LEDs lit: weak signal.
First, second and third LEDs on: good signal.
All 4 LEDs lit: optimal signal.
If only the last (fourth) LED is lit, the signal is too strong. Try setting the signal strength as explained
above.
Q10: How to reset the device?
A10: Press and hold the RST button for 6 seconds when the device is turned on.
Q11: Where to find the pairing code of the devices?
A11: Enter the device screen, click on System-Remote Management Settings. Check and enter the
pairing code, save to complete the operation. For more information, follow the instructions in the
Cloud manual.
8
Publicidad
