3. SETTING THE SIGNAL STRENGTH
If you want to change the settings of the AP. Follow the following settings.
1. Assign a static IP address to the PC in the same range as the AP:
Enter the IP address of the corresponding AP device in the IE browser to enter the WEB page, the
default password is "password". The signal strength can be set after login.
\
Transmit Power Configuration: Default is the maximum value, the transmit power should be redu-
ced appropriately when the signal is too strong.
Encryption Configuration: Custom key can be used for security. (The same key must be set in the
transmitter and receiver.)
6
Note: The subnet mask must be "255.255.0.0"
for IP "172.18.128.1".
Note: Ip address for 2.4G devices is 172.17.0.2
Subnet Mask is 255.255.0.0
Ip address for 5.8G devices is 172.18.0.2
Subnet Mask is 255.255.0.0