Pit Boss PB456D4 Montaje Y Operación página 9

5. INSTALLING THE HOPPER TO THE BARREL
Parts Required:
1 x Power Cord Bracket (#1)
1 x Probe Wire Casing (#2)
1 x Hopper Assembly (#10)
1 x Plate Screw (#11)
1 x Drop Chute Plate (#12)
4 x Screw (#A)
4 x Locking Washer (#C)
4 x Washer (#B)
Installation:
• Secure the plate screw to the cleanout plate, and insert into the
horizontal slit on the rear side of the hopper.
• Align the burn pot end of the hopper assembly into the opening on
the left side of the main barrel. Insert half-way, then carefully slide
the hopper assembly completely into the opening. Secure the hopper
assembly to the main barrel, from the inside of the barrel, using four
screws, locking washers, and washers. Take care not to over-tighten
to avoid stripping the screws. Note illustration 5A.
• On the rear side of the hopper, connect the silver grill probe
temperature wires – extruding from the main barrel – to the wire
connections from the rear of the hopper assembly. Note 5B. Remove
the two pre-mounted screws. Tuck the excess wire into the probe wire
casing, placing the wire distinctly in the divet along the edge to avoid
pinching. Next, secure the probe wire casing to the hopper using the
two screws previously removed. Note 5C.
IMPORTANT: Ensure the grill probe temperature wires do not get
pinched. Damage to the grill probe temperatures wires may result in
incorrect readings, or inability to funtion.
• Secure the power cord bracket using the two screws pre-installed
on the rear side of the hopper, above the drop chute plate. Note
illustration 5D.
6. ASSEMBLING THE LID HANDLE
Parts Required:
2 x Lid Handle Bezel (#8)
1 x Lid Handle (#9)
Installation:
• Remove the pre-installed hardware from the lid handle. From inside
the barrel lid, insert one screw to protrude to the outside. Add a bezel
on the screw, then hand-tighten the screw, locking washer, and washer
(from the inside) into the lid handle. Repeat same installation for other
end of lid handle.
5A
12
10
11
REAR VIEW
5B 5C
2
5D
1
6
8
8
9
9