RIDGID R4514T Manual Del Operador página 18

ASSEMBLY
MOUNTING HOLES
The table saw must be mounted to a firm supporting surface
such as a workbench or leg stand. Four bolt holes have been
provided in the saw's base for this purpose. Each of the
four mounting holes should be bolted securely using 1/4 in.
carriage bolts, washers, lock washers, and wing nuts. Bolts
should be of sufficient length to accommodate the saw base,
washers, lock washers, wing nuts, and the thickness of the
workbench. Tighten all four bolts securely.
Carefully check the workbench after mounting to make
sure that no movement can occur during use. If any tipping,
sliding, or walking is noted, secure the workbench to the
floor before operating.
MOUNTING THE TABLE SAW TO THE LEG
STAND
See Figure 14.
WARNING:
Do not lift the saw without help. The saw weighs
approximately 80 lbs. Hold it close to your body.
Keep your knees bent and lift with your legs, not
your back. Ignoring these precautions can result
in back injury.
 Open leg stand as described on page 26.
 Place saw base on the leg stand. Align the holes in the
saw base with the holes in the stand.
 Insert a bolt (M6 x 70 mm) through the hole in the table
saw and into the hole in the stand. Hand tighten using
hex nut (M6).
 For the remaining holes, insert the bolts through the hole
in the saw base and into the hole in the stand, then secure
to the stand using a hex nut.
 Tighten all hardware with a wrench and hex key. You may
find it helpful to use a wrench to hold the nut and the hex
key to tighten the bolt.
18 − English
BOLT
SAW
BASE
HEX
NUT
Fig. 14