Publicidad
Idiomas disponibles
Idiomas disponibles
About the control
and.
GEA liances.com
GeoSpring
O
O
@
-Fl:
Fotq
m HEAT PUMP
[
J
u HYBRID
u HIGH DEMAND/BOOST
u ELECTRIC/STANDARDFnl,'_
N VACATION
ode j
0
)
@
(on some models)
°
Hold for
Hold to Override
Hold to
°F/°C
PS-P(_werSaver
Reset
D
@
Control Features
1. Display
2. Operating Modes
(Seepage 8 for description)
3. Vacation
(Seepage 8 for description)
4. Mode Selector
Use this button to alternate between available modes.
5. Arrow Pads
Use these buttons to adjust the temperature
setting.
6. Enter Key
7. Filter Reset
The filter is dirty and requires cleaning when the Red light is
illuminated. Filter is located on top of the water heater. Press
button and hold for 5 seconds to reset filter alarm.
J
8. Power Saver Override
For use with ACM module. Press and hold to bring unit out of
Power Saver mode. Once pressed and Power Saver mode is
cancelled, unit will remain out of Power Saver for the next 18
hours.
9. Appliance Communication Module Port
For use with optional ACM module (see page 10 for details).
10. Anode Reset (on some models)
When the red light is illuminated, the system has indicated that
the anode rod is approaching end of life and it is recommended
to replace it. Press button once to silence alarm. Press and
hold for 10 seconds to reset the anode alarm after replacing.
Call GE service to replace the anode rod. Failure to replace the
anode rod will void warranty coverage and may result in a tank
leak. (Seepage 14 for instructions to change the anode rod.)
GE Service:888.4GE.HEWH(888.443.4394).
11. Communication
Indicator
The LEDis illuminated when the GeoSpring is enabled for
communication
through the ACM module. See page 10 for
description.
Publicidad
