Clearing Locking Authorisations - hafele Dialock FT 120 Instrucciones De Funcionamiento

6.2 Individually
addressable operation
7.

Clearing locking authorisations

7.1 Clearing the locking
authorisation of
individual keys
7.2 Procedure to follow if a
user key is lost
14
In order to be able to assign locking authorisations, the addresses of the locks must be defined.
This operating mode can only be used in conjunction with the MLA 8.
Output
1
EFL 3
1
EFL 3
MLA 6
Power Output
Adresse
Antenna/LED
Adress
Adresse
Dirección
Indirizzo
Address 1 is reserved for the lock directly connected to the FT 120. The first lock that is connected
to the MLA 8 has address 2, the second has address 3, etc. These addresses must be considered
when allocating the locking authorisations. Locking authorisations for several addresses or locks
can be assigned to one user key, for example, for lock 1, 4 and 7.
For step-by-step instructions „Allocating locking authorisations - individually
addressable (with MLA 8)" see illustrations starting on page 46.
For step-by-step instructions „Clearing individual locking authorisations"
see illustrations starting on page 47.
If a user key is lost, all user keys must be cleared from the FT 120.
For step-by-step instructions „Clearing all locking authorisations" see
illustrations starting on page 48.
Then locking authorisations must be allocated to all of the required user keys again
(see chapter „6. Allocating locking authorisations").
PS1 / PS2
FT 120
Power
supply
Output/
MLA 8
Adresse
Adress
Adresse
Dirección
Indirizzo
2
EFL 3
3
EFL 3
Power
4
in
EFL 3
FT 120
5
2
EFL 3
EFL 3
3
EFL 3
6
EFL 3 4
EFL 3
5
EFL 3
6 7
EFL 3
EFL 3
7
EFL 3
8 8
EFL 3
EFL 3
9
EFL 3
9
EFL 3