Sirena LPL 600 Instrucciones De Instalacion Y Uso página 6

COMPONENTS
OPERATION
LPL 600 - LPL 900
The lamp will turn on automatically when it is powered.
LPL 600 SENSOR - LPL 900 SENSOR
At each power up LPL will flash for 15 seconds for sensor stabilization.
The lamp is equipped with a sensor that will turn on the LEDs when it detects movement.
It will automatically turn o a er 3 minutes from the last motion detected.
POWER CONNECTION
To connect and disconnect the cables, simply press the buttons in the figure.
SERIES CONNECTION
In both versions it is possible to connect multiple lamps in series using cables with a maximum section of
1.5mm or using the bridge supplied via the connectors in the figure.
To connect and disconnect the cables, simply press the buttons in the figure.
Check in the table below how many LPL can be connected according to the version and voltage.
PUSH
Power
connection
LPL 12/24V AC/DC
INSTALLATION AND USE INSTRUCTIONS
Button
Connector
Series connection
NUMBER OF LPL THAT CAN BE CONNECTED IN SERIES
12
LPL600 5
LPL900 3
Button
Motion
sensor
via cables
24 12 24
6 6 8
5 3 7
Allineare
Allineare
Series connection
via bridge
48
8
8
EN