Before using the cooktop for the first time
• All products are wiped clean with solvents at the factory to
remove any visible signs of dirt, oil, and grease which may
have remained from the manufacturing process.
• Clean your glass top before the first time you use it. A
thorough cleaning with a glass top cleaner is recommended.
It only takes a minute and puts a clean, shiny coating on the
glass top before its initial use.
• There may be a slight odour during the first several uses: this
is normal and will disappear.
• Optimum cooking result depends on the proper cookware
being selected and used.
• The cooking surface will hold the heat and remain hot over
20 minutes after the elements have been turned off.
• The glass ceramic cooking surface is a durable material
resistant to impact but not unbreakable if a pan or other
object is dropped on it.
• Do nor allow pans to boil dry. This can damage the pan,
element and /or cooktop.
• Do not slide cookware across cooking surface it may scratch
the glass
Power Sharing
One generator controls 2 elements, or two/three cooking
zones within a heating section share the power of one
generator. Power Sharing is activated when both elements in
the same cooking zone are activated and one element is set for
Boost (P). The element that is not set for Boost will change to a
lower power level. This is called Power Sharing: The latest set
cooking level has priority.
30"
INDUCTION
7 - Induction Cooktop Operation
36"
IMPORTANT
Automatic Switch OFF
The induction hob has an automatic device which limits the
duration of use.
Depending on the chosen cooking level a maximum
operation time limitation is defined, the safety device will be
activated only if no change of cooking level is done. If this
maximum operating time is exceeded on a cooking zone
this cooking zone is being switched off, a short beep sounds
and if the zone is hot the "residual heat" symbol is showed.
In order to reactivate this cooking zone the control knob has
to be turned back into OFF position.
EN
11