Publicidad
Idiomas disponibles
Idiomas disponibles
VIDEO/AUX
TUNER
BAND
TAPE
=O
SETTING THE TIMER
The unit can be turned on at @ specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly. (See page 12.)
Use the remote control.
1 Press the TIMER button once to display ©, and
press the Il SET button within
4 seconds.
© is displayed, and the hour flashes.
If you do not press the It SET button within 4 seconds, another
operation may start.
2 Designate the hour of the timer-on time by
pressing the <4 DOWN or UP »
button, and
the Il SET button. Repeat to designate the minute
of the timer-on time.
After you designate the timer-on time, TIMER and one of the
source names flash alternately on the display for 4 seconds.
3 Within 4 seconds, press one of the function
buttons to select a source.
TIMER and the selected source name flash alternately for 4
seconds. At this time, the selected function button does not
light up.
* If this step is not completed within 4 seconds, repeat from
step 1.
+ Ifthe TUNER button is pressed, the band cannot be selected
in this step.
Within
4 seconds, select the duration for the
timer-activated period with the << DOWN or UP
>> button.
The duration for the timer-activated period can be set between
10 and 240 minutes in 10-minute steps.
* If this step is not completed within 4 seconds, repeat from
step 1.
5 Prepare the source.
To listen to a CD, load the disc to be played first on tray 1.
To listen to a tape, insert the tape into the deck.
To listen to the radio, tune in to a station.
6 Press the POWER button to turn the unit off after
adjusting the volume and tone.
© remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
a
To check the specified time and source
Press the TIMER button. The timer-on time and the selected
source name are displayed for 4 seconds. However, the duration
for the timer-activated period will not be displayed.
TIMER RECORDING
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press the TIMER
button twice so that
appears on the
display, and press the fH SET button within 4 seconds.
Repeat the steps shown above from steps 2 to 5 and insert the
tape to be recorded into deck 2.
Publicidad
