Publicidad
Idiomas disponibles
Idiomas disponibles
Float/Cage Assembly
,_k WARNING:
For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate vac with
any parts damaged or missing.
1. Remove the detachable blower from
the power head assembly by pressing
down on the power head latch
beneath the carry handle of the
detachable blower. Set the detachable
blower off to the side. Place lid upside
down on the drum.
2. Locate the float and filter cage.
3. Place the float over the opening in the
center of the lid with the words "This
Side Towards Lid" laying face down
over the hole. (See illustration.)
WARNING:
To avoid personal
injury or damage to vac be sure to
keep hands, fingers, or any other for-
eign objects out of the center opening
when assembling the float.
4. Line up filter cage tabs, as shown,
with the slots in the center ring of the
lid assembly. Push on the filter cage
until the tabs snap into slots for a
secure fit.
NOTE: If filter cage needs to be removed,
or replaced, because the float is placed in
the wrong way, use a flat blade screwdriv-
er and insert the blade near one of the
tabs between the filter cage and the cen-
ter ring of the lid. Pry the tab out of the
slot. Tilt the cage and lift away from the
lid. To replace, follow Float/Cage
Assembly instructions.
Carry Handle
Power Head
Assembly
Power
Assembly
_
ilter Cage
Tabs (3)
Slots (3)
Slots
(3)
Publicidad
